C Series

Rex C-Series is a self-supporting version of the Rex Joints, which requires, no external supports of any kind. They are the best known, most widely used in Paper, Textile, Plastics, Rubber, Chemical, Food and many other industries. They are available for through-flow service and stationary siphon pipe applications. Standard series joints are suitable for pressure up to150 PSI. The C-Series Rex Joints are regularly furnished with cast iron housing and end cover. The carbon or carbon filled PTFE seal ring under compression rather than tensile load provides higher strength and exceptional service life. Two wide spaced carbon bush bearing ensure absolute support and substantially reduced wear. The carbon bush bearings are made of specially formulated carbon graphite and seal rings are made of carbon filled P.T.F.E. which require no lubrication of any sort. The spring is made of the finest spring steel stainless steel wire for better resistant to rust, corrosion and erosion. They are available in sizes from ½” to 4”.

THE BENEFITS

• Greater joint stability : Two wide spaced carbon bush bearing for greater support, stability and longer wear. This cross sectional area allows greater stability and resistance to side loads.
• Longer seal life : Large, improved seal under compression design provides long life. Plus greater joint stability reduces seal wear, leakage, and maintenance requirements.
• Self-supporting configuration : Tolerates journal misalignment better that externally rod-supported configurations.
• No lubrication required : Maintenance is minimized.
• Self-adjusting for seal wear and pressure changes : Maintains leak-free sealing under changing conditions.
• Wide range of available constructions : Different materials let you configure the joint for maximum durability under your application conditions.